|
Challenge
MS-10A Multi-Spindle Drill
-
High Production Multi-Hole Drilling
-
Drills Up To 10 Holes in One Stroke
-
Maximum Drill Bit Diameter 1/2"
-
-
Powerful Hydraulic Operation
-
-
Variable Speed Stroke Control
-
Automatic Paper Chip Removal
-
Rugged Cast Iron Construction
-
Flexible Side Guide Adjustments
-
Multi-Splined Drive Shaft
-
-
S p e c i f i c a t i o n s
-
Maximum Number of Drill Heads: 10 Heads
-
Drill Sizes Available** (2" capacity):
1/8" to 1/2" / 3 to 13 mm
-
Drill Sizes Available (2-1/2" capacity):
1/4" to 1/2" / 6 to 13 mm
-
Center to Center Distance Maximum: 21"
/ 53 cm
-
Center to Center Distance Minimum***:
1-1/4" / 3.2 cm
-
Minimum Distance Between Holes w/ Adj.
Stops: 3/8" / 9.5 cm
-
Minimum Distance Between Holes w/ Fixed
Gauges: 1/4" / 6 mm
-
Maximum Drilling Capacity: 2-1/2"
/ 6.35 cm
-
Strokes per Minute (adjustable): 18
to 26
-
Backgauge Adjustment: 0 to 9" /
0 to 23 cm
-
Vertical Adjustment of Individual Heads:
1/4" / 6 mm
-
Table Size: 24" x 36"
/ 61 x 91 cm
-
Table Height: 38" / 96.5
cm
-
Overall Height: 60" / 152
cm
-
Floor Space Needed: 35"
x 40" / 89 x 102 cm
-
Net Weight (approximate): 1350
lbs / 675 kg
-
Shipping Weight (approximate):
1660 lbs / 830 kg
- 3 Phase, 60 Hz, AC. Pump: 3/4 HP. Spindle Motor: 3 HP.
- 208 Volts, 14 Amps (service size 20 Amps)
- 230 Volts, 12.8 Amps (service size 20 Amps)
- 460 Volts, 6.6 Amps (service size 15 Amps)
- 1 Phase, 60 Hz, AC. Pump: 3/4 HP. Spindle Motor: 3 HP
- 208 Volts, 26.5 Amps (service size 40 Amps)
- 230 Volts, 24.2 Amps (service size 40 Amps)
** Special large hole drilling (up
to 1-3/4" in diameter) is possible with conversion
kit.
*** Three hole drilling heads are available for drilling
3 holes in 1" centers.
|
|
|
|
